Starvin Larry

Via Field&Stream

(be sure to read the linked article on firelapping at bottom of post-and RTWT)

Follow these tips to eke out optimum ­accuracy from your in-line muzzleloader.

1. Fire It Smooth

The barrel is the most important component of a tack-driving smokepole. Any imperfections in the bore will hurt accuracy. So get a fire-lapping kit for muzzleloaders ($50; ­bear tooth ­bullets.com) and shoot 15 to 20 of the provided soft-lead bullets as directed. These have various grit compounds that will polish smooth any defects.

2. Mount It Right

Once you’ve perfected the barrel, do the same with your scope rings, using a kit like the Wheeler Engineering Scope Ring Alignment and Lapping Kit ($45–$62; midwayusa.com). This will take off any residual manufacturing marks that could allow the scope to shift after a shot. Most kits provide leveling bars that will ensure the scope runs perfectly parallel to the bore.

3. Get Loose

Granulated powders can be measured and fine-tuned more precisely than preformed pellets, yielding better shot-to-shot consistency. “Like a hand­loader developing recipes, a muzzle­loader shooter can adjust a loose-powder charge to perfectly match a specific bullet-and-gun combination,” says Chris Hodgdon of Hodgdon Powders (hodgdon.com).

4. Find Your Bullet

Pick a few bullets from the top manufacturers, like Barnes, Hornady, Power­Belt, and Thompson/Center, in a variety of weights for the game you’re after. For whitetails, stay in the 250- to 300-grain zone. Shoot each combination of brand, weight, and powder until you hit your smallest groups. Be systematic and clean the barrel after each shot. You may just squeeze MOA accuracy out of that smokepole yet.

***Related very long,but very imp0rtant article on firelapping muzzleloaders to greatly improve accuracy,and greatly lessen barrel fouling.***

Be sure to RTWT…

firelapping muzzleloaders

Firelapping can improve accuracy by as much as 50%,so it’s well worth the time and minimal investment.

Pay close attention to the process-and take note-you have to use real black powder-no Pyrodex,no Triple7, and no pellets-good old Goex blackpowder must be used-or whatever other brand you prefer.

The reason is the way black powder burns vs Pyrodex,etc. The Pyrodex,etc. does not reach full pressure until the bullet is well on it’s way down the barrel,so a good part of your barrel will not be lapped unless you use real black powder.

I’m going to firelap my sidelock and my inline in the next month or so,I’ll post before and after targets from 50,75,and 100 yds.

My brother in law firelapped his old CVA sidelock muzzeloader,and went from 6-8 inch groups at 100 yds to 3-4 inch groups at 100 yds. He’s also used the process on a couple centerfire bolt actions-a .243 and a .308 and got even better results.

He’s 100% sold on the process,and he’s a gunsmith,certified armorer,etc,etc.

They also have no kids-so he’s got way more time and $$$ to spend on shooting/firearms.

Read more.

Learn more.

Train more.

Do more PT.

You don’t have enough ammo.